rear wheel bearing took 4 tons!
#1
rear wheel bearing took 4 tons!
<center><img src="http://pictureposter.audiworld.com/79797/bearing.jpg"></center><p>It took a full 4 tons of pressure to knock the old bearing out of the upright! I tried initially, but the press knocked the middle of the bearing out and the race ended up stuck in the upright. HUGE PAIN! Finnaly, after much frustration, we just put it in the press again and put as much pressure as we could. Apparently, the stainless steel was firmly bonded to the upright, so when in doubt, snap the stainless steel!
Thread
Thread Starter
Forum
Replies
Last Post
tmanley
A4 (B5 Platform) Discussion
12
05-21-2011 10:23 AM
dvandentop
S4 / RS4 (B5 Platform) Discussion
0
12-29-2002 08:13 AM