Milltek exhaust & hi-flow catback...
#1
Milltek exhaust & hi-flow catback...
arrived today, but I'm a little bummed. The back end of the hi-flow cats is kind of flat on one side instead of being completely round. In addition, the left exhaust tip on the silencer has a couple of dents & dings far enough back that I think they'll be visible. Right side is a little scuffed; can I buff it out? Is this being ****? I know the thing will perform, but I was hoping aesthetically it would be equally tight. Anybody here want to set me straight on my expectations? TIA!
#2
Call Pete and explain...if you got it from them....He'll either console you and explain
that they all have a little nick here a ding there. Or, he'll ask if you want another one, if in fact you are displeased about it. But, you pay for the shipping unless you negotiate that, too.
#4
Re: Call Pete
This I know, thank goodness! The guys at Stratmosphere are pros - I've always had great customer service with Bob and Pete. I'm sure they will take care of me. Since this is my first aftermarket exhaust though, I wasn't sure what "normal" was.
Thread
Thread Starter
Forum
Replies
Last Post
bostonS6
New England Discussion
32
06-28-2008 07:03 PM
bostonS6
A6 / S6 (C6 Platform) Discussion
4
06-26-2008 12:09 PM
ssTechnik
S4 (B6 & B7 Platforms) Discussion
10
01-17-2005 08:14 AM
UK_Reading_AudiA4Cab
A4 Cabriolet (B6 Platform) Discussion
5
06-30-2003 09:52 AM
Hokie - STI avant
Audi 90 / 80 / Coupe quattro / Cabriolet
1
12-27-2002 11:16 AM