OCT innercooler?
#13
I used to have a link to a great step by step w/photos too...
sorry to say link no longer works....But try a search under FMIC or front end removal. The front end removal is really the only part worthy of note. Quick list here.
1. Raise front end and remove both front wheels
2. Remove wheel well liners (or at least the front 6-8 screws) and access two 10mm nuts on each side of the front end
3. Remove all screws on top and 2 underneath nose
4. Disconnect and drain into bucket contents of washer reservoir (quick disconnect in front of drivers side wheel
5. Slide front end forward until off the car and place on blanket.
6. Follow directions that should come with the FMIC.
If you have any more questions e-mail me at work I have some drawings there that show locations of the items I'm talking about here.
rharper@kopin.com
1. Raise front end and remove both front wheels
2. Remove wheel well liners (or at least the front 6-8 screws) and access two 10mm nuts on each side of the front end
3. Remove all screws on top and 2 underneath nose
4. Disconnect and drain into bucket contents of washer reservoir (quick disconnect in front of drivers side wheel
5. Slide front end forward until off the car and place on blanket.
6. Follow directions that should come with the FMIC.
If you have any more questions e-mail me at work I have some drawings there that show locations of the items I'm talking about here.
rharper@kopin.com
Thread
Thread Starter
Forum
Replies
Last Post
Are some MBC's better than others? Or are they pretty much all the same? I have a forge and it seems
~DonQPremiumTequila~
S4 / RS4 (B5 Platform) Discussion
7
10-04-2006 11:53 AM
Al Nuggs
A4 (B5 Platform) Discussion
8
12-08-2004 09:28 AM
the senator
A4 (B6 Platform) Discussion
1
07-07-2003 03:23 PM
nauticacomp
S4 / RS4 (B5 Platform) Discussion
6
09-10-2002 05:22 AM