On recycling control arms...
#1
On recycling control arms...
I had Koni CO installed and replaced 8-control arms last week (cost $570 including alignment, I will get another alignment in 4-6 weeks).
The installer was very knowledgable about suspensions, and we talked about CA bushing wearing out on A4s. He said he could press new bushings into my old CAs, but cautioned me that the ball joints will only last for ~100k miles.
He even showed me a reference book where the Audi CA bushing was clearly marked as a separate part (~$53per, but he said that that just because the part # exists, doesn't mean Audi will let me buy them).
When my CAs start acting up again, I might try my luck with Clairparts to get those bushings, and repress my old CAs.
The installer was very knowledgable about suspensions, and we talked about CA bushing wearing out on A4s. He said he could press new bushings into my old CAs, but cautioned me that the ball joints will only last for ~100k miles.
He even showed me a reference book where the Audi CA bushing was clearly marked as a separate part (~$53per, but he said that that just because the part # exists, doesn't mean Audi will let me buy them).
When my CAs start acting up again, I might try my luck with Clairparts to get those bushings, and repress my old CAs.
Thread
Thread Starter
Forum
Replies
Last Post
Bobby Kinstle
A4 (B5 Platform) Discussion
7
07-15-2005 06:07 PM
OHQuattros(tehblur)
A4 (B5 Platform) Discussion
0
12-04-2004 10:41 AM