Removing clutch fan without special tool...
Thread Starter
AudiWorld Senior Member
Joined: Jul 2005
Posts: 987
Likes: 0
Removing clutch fan without special tool...
So I've pulled the plastic fan itself by removing the four little allen bolts and now I'm trying to figure out how I'm going remove the reverse threaded nut to actually pull the fan clutch off. I've looked around at some of the timing belt walk-throughs and they always say "I was able to figure it out by improvising". One said they used a little allen wrench to jam into one of the pulley's holes. I wasn't able to get anything to hold it as tightly as necessary.
Thanks.
Thanks.
Trending Topics
I was lost, now I'm found
Joined: Apr 2008
Posts: 6,223
Likes: 0
How I did it.
I put a long thin screw driver (red line) between the tabs (yellow arrow) and through a hole in the pulley. There is an allan bolt (blue arrow) behind the assembly that screws into the pulley that needs to be loosened and removed. Hope this helps.
<img src="http://i484.photobucket.com/albums/rr209/myersct2/cfanA.jpg">
Yah I know I got mad paintz skillz.
<img src="http://i484.photobucket.com/albums/rr209/myersct2/cfanA.jpg">
Yah I know I got mad paintz skillz.
AudiWorld Stories
Bringing Audi to Life for Audi Fans
Top 10 Most Expensive Audis Ever Sold on Bring-A-Trailer
Brett Foote
10 Audi Features & Options We Miss the Most!
Joe Kucinski
Audi Recreates Crazy-Looking Speed Record Breaker From 1935
Verdad Gallardo
Coachbuilder Recreates the 1995 Audi TTS Concept
Verdad Gallardo
Every Audi V10 Car Ranked!
Joe Kucinski
9 Audi Designs That Aged Like Fine Wine
Verdad Gallardo
2026 Audi Q5 Buyer's Guide (Every Model Explained)
Brett Foote
Ranking Every Current Audi 'S' Model From Worst to First!
Joe Kucinski
10 Best Audis That are FINALLY LEGAL to Import to the U.S.!
Joe Kucinski
AudiWorld Super User
Joined: Feb 2003
Posts: 19,421
Likes: 1
*sigh* I had a long and hard problem getting mine off.
<center><img src="http://pictureposter.audiworld.com/51968/s5300622c.jpg"></center><p>
*hehe* Everyone said it was going to be reverse threaded, but after I broke the first aluminium tab trying to get it loose by pushing the wrench to the right and slamming my hand into a bloody mess i decided maybe it went the other way. I broke the tab holding the allen trying to go the other way too. So I gave up and ordered a spanner wrench. Waited for it, and took off the long bolt by turning towards the drivers side quarter panel and resting the spanner wrench against the A/C pulley(?). That would make it normal threaded correct?
In the pic, i broke the little tabs that are supposed to hold the metal pin that is supposed to stop the pulley from spinning.
*hehe* Everyone said it was going to be reverse threaded, but after I broke the first aluminium tab trying to get it loose by pushing the wrench to the right and slamming my hand into a bloody mess i decided maybe it went the other way. I broke the tab holding the allen trying to go the other way too. So I gave up and ordered a spanner wrench. Waited for it, and took off the long bolt by turning towards the drivers side quarter panel and resting the spanner wrench against the A/C pulley(?). That would make it normal threaded correct?
In the pic, i broke the little tabs that are supposed to hold the metal pin that is supposed to stop the pulley from spinning.
