Is there a way to tell from a vag scan when somthing happened?
#1
Is there a way to tell from a vag scan when somthing happened?
I just realized today that about $400 of stuff was stolen from my car in the last few days. I did a vag scan because i knew it showed if the alarm had gone off and it came up with this:
00962 - Alarm via. Tilt Sensor
35-00 - -
01374 - Alarm triggered by Terminal 15
35-00 - -
01371 - Alarm triggered by Door Contact Switch; Driver's Side
35-00 - -
01572 - Alarm triggered by Door Contact Switch; Passenger Side
35-00 - -
I think the tilt is from when my alarm went off because my car rolled down my friends driveway, i think the other three may be from when the stuff was stolen. How are those the other three sensors activated?
00962 - Alarm via. Tilt Sensor
35-00 - -
01374 - Alarm triggered by Terminal 15
35-00 - -
01371 - Alarm triggered by Door Contact Switch; Driver's Side
35-00 - -
01572 - Alarm triggered by Door Contact Switch; Passenger Side
35-00 - -
I think the tilt is from when my alarm went off because my car rolled down my friends driveway, i think the other three may be from when the stuff was stolen. How are those the other three sensors activated?
#2
I don't thinks it's possible. ....
The first thought was that maybe in generic mode the time stamps for the DTCs could be seen in the "freeze frame" data, but I don't think that works in any controllers except the engine ECU.
Thread
Thread Starter
Forum
Replies
Last Post
uble1234
A6 / S6 (C6 Platform) Discussion
14
10-23-2020 08:07 PM
brandonb93
A4 (B7 Platform) Discussion
12
12-04-2018 01:16 PM
Audi A6 2005 allroad 2.7t 6mt
mzguy
Vehicles For Sale - Archive (NO NEW POSTS HERE)
14
12-31-2015 06:28 AM