obo110x

Hi,
I have cured the steering angle fault by performing the calibration routine - go figure!

I can now enter the security access code and access the controller, but get stuck at the adaptation phase, the initiate calibration just seems to sit there and wait for minutes without progressing, the "Read" button remains disabled. It's dark and raining here now so i'll try again tomorrow.
Thanks all

obo110x

Yes relay was replaced too.

mishar

Why are you adjusting your ride height?

obo110x

It is still stuck at Lift height, even though the MMI display shows Dynamic setting. I also have the persistent fault of upper limit exceeded due to the current ride height.

obo110x

Turned out to be a faulty new compressor, the valve that lets air out of the system wasn't letting air out!