hevnsnt

This thread is getting some more attention due to another thread. I just wanted to come in here and say that I would strongly recommend soldering over crimp type connectors. The doors get a lot of movement, slams, bumps, etc -- in a couple years you might have some crimps come loose that will drive you crazy.

Tbone323

caranddriver

Great ingenuity. I don't have a Prestige, but it mystified me why Audi would cheap out and not sync the speaker light with the rest of the changeable LEDs.

If people are going to be taking their door panels off, might as well buy some Dynamat and get rid of the buzzing that seems to afflict the B&O speakers.

Aeroboiler

Yoshimura

You know the byte / bit of loudspeaker_gate_illumination?

Thes6isWicked

Reviving an old thread: Anyone found an actual wiring harness that might accomplish the same thing?

bruce_miranda

Knock your door panel off and check the part number of the plug that goes into one of the 4 pin LED modules. Then just buy 2 males and 1 female and make a parallel connection harness.

Thes6isWicked

Not a particularly bad idea....
I have one options that already has this same configuration, but I'm awaiting a response from the AliExpress vendor to see if s/he could delete the light tube.
Basically, modify the dashboard ambient light addition/mod, to just the module and harness....

synergize

Supposedly there is a complete kit to accomplish this: https://www.audizine.com/forum/showt...our-dash-trims scroll down to bottom of the page...they talk about the speaker/light kit.

If you find out any info post back...I don't have the right accounts to contact the seller.

Stefan Nordin

Hi, is it possible to change from oroginal grills to B&O grills and get the light at the grills? I have the lightpackage in the car and the led stripes up at the door.