I was lucky enough to strip my rear axle bolt last night. Any idea's on how to remove this thing.
#1
AudiWorld Senior Member
Thread Starter
I was lucky enough to strip my rear axle bolt last night. Any idea's on how to remove this thing.
The 14mm hex bolt head is rounded out. I use a breaker bar and 6 foot pipe extension. The bolt would not budge. My pipe never failed me until now.
#4
Been here before so I'll chime in...
When this happened to me it took four days to get that sucka off.
I carved a notch on one side of the head of said bolt. Used a good size chisel and a hefty hammer. Then use the same tools to drive the bolt counter-clockwise.
It took me four days to realize that I was wasting my time with my little claw hammer. Trust me get a big hammer. Be careful and dont give up. You should be fine.
HTH
I carved a notch on one side of the head of said bolt. Used a good size chisel and a hefty hammer. Then use the same tools to drive the bolt counter-clockwise.
It took me four days to realize that I was wasting my time with my little claw hammer. Trust me get a big hammer. Be careful and dont give up. You should be fine.
HTH
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
B56
A4 (B5 Platform) Discussion
26
09-19-2008 06:21 AM
inliner311
S4 / RS4 (B5 Platform) Discussion
9
12-17-2006 12:01 PM
gadgetmeister2711
A4 (B5 Platform) Discussion
15
08-04-2004 09:17 AM
a4rn
A4 (B5 Platform) Discussion
3
12-14-2003 02:00 PM