Reseting Ecu to unplug MAF....just disconnect ECU for a lil while? or disconnect battery too?
#1
Reseting Ecu to unplug MAF....just disconnect ECU for a lil while? or disconnect battery too?
Had a Code thrown For the MAF sensor(G70): Signal to Low p0102-35-10---intermittent
Now i figure my MAF is bad since its the Bosch one.....but i was also thinking it might be due to a leak i had causing unmetered air entering the system
When reseting the ECU.. couldn't i just disconnect the battery for a while instead of unpluging the ECU?? what are my choices? TIA
Now i figure my MAF is bad since its the Bosch one.....but i was also thinking it might be due to a leak i had causing unmetered air entering the system
When reseting the ECU.. couldn't i just disconnect the battery for a while instead of unpluging the ECU?? what are my choices? TIA
Thread
Thread Starter
Forum
Replies
Last Post
bushido
A4 (B5 Platform) Discussion
2
03-11-2002 12:29 PM