Ed@mtl

<center><img src="http://img.photobucket.com/albums/v105/hobbesmickey/DSC00872.jpg"></center><p>Besides the RS4 pedal set. The Carbonio intake has been installed. Oh, changed the HID to 6000K as well (didn't need to remove the front bumper).

Installing this week will be the Milltek exhaust and the RS4 rear sway bar. Still waiting for the REVO software, they don't have one yet for my ECU (too new they say).

I did save one mod for next Spring, the coilovers and of course the 19".

That's all. After that, I'm stopping.

A4TABT

change the HID bulbs without removing the bumper, my shop people told me it's not possible without removing front bumper..

Ed@mtl

Started out installing the Carbonio first and realize that I had access to the back of the headlight casing. Wasn't too sure for the driver side but after moving the washer fluid and the power steering reservoir out of the way. There she was, the back of headlight casing.

Another words, on the driver side, you'll need to move the washer fluid and the power steering reservoir out of the way. On the passenger side, you'll need to remove the air filter box.

A4TABT

sounds like a easier route to go, will take a look today if I have time, thanks a lot

Ronin//1.8T

You car is only one month old and look all mods you done all ready

Ed@mtl

Actually, 23 days old

Alias Unknown

LOL... thats friggin awesome. Less than a month and then BAM! Not one mod but a bunch of them!

quattro25

Ed why dont you use Unitronic chip???

Ed@mtl

Hey Phil, what's up... Cause I'm getting a good deal, a very good deal on the Revo.