Boosted2001

Hey all, recently added another Audi to the stable, this one is an 04 A8L. It came with a few issues, one is the wiring to the ABS brake pressure sensor on the outboard drivers side of the ABS module above the LH front wheel. It has the G201 code, electrical failure, and found that the previous owner did a very poor job of repairing the harness, such that all three wires into the connector have disconnected. To finish the repair, I'm looking for either a harness schematic drawing, or a picture of the wires going into that connector (prob not likely, I know...).

If anyone could help point me to the wiring diagram, that would be much appreciated! Thanks!

Mister Bally

Wiring diagram is in the service manual. Www.bentleypublishers.com

the_duke

I tried attach a pdf wiring diagram we will see if it works.

Alfredoa8l

Hello, does anyone has a DIY location or procedure on how to replace the brake pressure sensor on a 2004 D3 a8l,,,, I heard different stories like its integrated on the ABS pump witch is like $900 so I hope I don't have to do that,, I hope you guys can help me out thanks

Mister Bally

I do not.